Woodway DESMO '05 Owner's Manual download pdf (Page 68)

FORM: OWNERS MNUL

REV: 02-16-11

APPR BY: MF

Lubrication

Bearings

Almost all of the bearings used in the treadmill are pre-lubricated and do not need to be

greased. On a yearly basis, the four (4) bearings located at the front and rear shaft will

need to be lubricated.

Running Belt/Drive Shaft

The teeth on the bottom of the running belt are pre-lubricated to aid in reducing noise.

There is no need to lubricate the teeth. If running belt is rubbing against the side of the

drive pulleys, then a small amount of grease (i.e. Molykote or equal) on the edges of the

belt slats will help reduce noise. Apply grease to the teeth on the back drive shaft to

help the belt stay aligned properly.

Drive Belt

As in the case of the running belt, the application of grease on the edge of the drive belt

is only needed to reduce belt squeak and should be used sparingly.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 78 79

No comments

Woodway DESMO '05 Owner's Manual Page 68