Woodway PPS 70 Owner's Manual download pdf (Page 43)

FORM: PPS SERIES OWNERS MNUL

REV: 02-18-2013

APPR BY: BW

Outer Covering

Removal:

Disconnect the treadmill from the mains and remove the two (2) large screws in the

outer covering using a cross-recess screwdriver. The covers can then be lifted up from

the frame of the treadmill.

Replacement:

Position the two outer coverings on both sides of the frame. Then tighten the large

screws. It is important to check whether the treadmill scrapes on the covering panels by

moving the mat backwards and forwards. If this is in fact the case, the screws must be

loosened again and the covers moved away from the mat.

Manual Display

Required tools: cross-recess wrench / 10 mm / 10 mm ring forked wrench.

Removal:

1. Unscrew the fastening screws on the back of the plastic housing until the front

section can be removed.

2. Lift the entire unit out of the housing.

3. Disconnect the BUS cable by pulling the plug only (never pull the cable).

Replacement:

1. Connect the cable and plug again.

2. Then carefully insert the complete display from above, taking care not to crush

the cables.

3. Insert the small screws through the back of the housing.

4. Switch on the power supply and check that the treadmill works properly.

Drive Motor and Pulley

The instructions are supplied with the new or replacement motor, pulley is included.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 54 55

No comments

Woodway PPS 70 Owner's Manual Page 43